Hi,
I’m struggling quite a bit with Exim configuration, as I was accustomed with Postfix, much easier in my opinion.
After a fresh install of Hestia and WordPress, I tried to send an email notification from WP, but the message gets stuck in queue. Same with local mail sent to admin user that gets “frozen”.
I looked up in Hestia documentation, but there’s no tutorial about Exim, and in the forum there’s a lot of messages on this topic but no one that gives the full picture…
-
First of all, which kind of setup (i.e. “Internet site”, “Smart host”, etc) is configured with a fresh Hestia installation?
-
May I use
dpkg-reconfigure exim4-config
to reconfigure Exim?